MJK0003 Vector Collette Granulator MDL GRAL10

1- Used Vector Collette Granulator MDL GRAL10 Specifications Name: GRAL10 MDL: 10 MFG: 1997 Power Supply: 480 Volts / 60 Hz / 3 Phase.  Largest / Full Load: 6A.   Construction: Stainless steel product contact surfaces, Capacity: 10-liter non-jacketed bowl, manual bowl lift on base Chopper Power: .75/.55 kw 220 volt General Information Granulators and High Shear mixers are an effective means for turning powders into dense granules for tableting or coating. To create the granules, powders are added to the mixing bowl and the bowl is sealed. If necessary a dry binder may be added with the powders or dispersed into the granulating liquid. A large impeller spins at fairly slow speeds spinning the powders into a vortex. After the powders are blended together, the liquid is added to the product using a pump or pressurized container. A chopper tool located in the bowl spins at fairly high speeds shearing the granules and removing air. The mixing continues until the desired end granule size and density is achieved. The endpoint is often determined via power consumption or torque of the main mixing tool drive. The granulated product may be dried in the mixing bowl if equipped for vacuum drying or discharged for fluid bed drying.  Location: Azusa, CA 91702
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
Image for MJK0003 Vector Collette Granulator MDL GRAL10 thumb
1- Used Vector Collette Granulator MDL GRAL10
Specifications

Name: GRAL10
MDL: 10
MFG: 1997
Power Supply: 480 Volts / 60 Hz / 3 Phase. 
Largest / Full Load: 6A.  
Construction: Stainless steel product contact surfaces,
Capacity: 10-liter non-jacketed bowl, manual bowl lift on base
Chopper Power: .75/.55 kw 220 volt

General Information
Granulators and High Shear mixers are an effective means for turning powders into dense granules for tableting or coating. To create the granules, powders are added to the mixing bowl and the bowl is sealed. If necessary a dry binder may be added with the powders or dispersed into the granulating liquid. A large impeller spins at fairly slow speeds spinning the powders into a vortex. After the powders are blended together, the liquid is added to the product using a pump or pressurized container. A chopper tool located in the bowl spins at fairly high speeds shearing the granules and removing air. The mixing continues until the desired end granule size and density is achieved. The endpoint is often determined via power consumption or torque of the main mixing tool drive. The granulated product may be dried in the mixing bowl if equipped for vacuum drying or discharged for fluid bed drying. 

Location: Azusa, CA 91702